Two-Component Adhesive Mixing and Dispensing

In general, when coating two-component adhesives on materials, it is necessary to pre-mix the two components before dispensing. As two-component adhesives begin to solidify after mixing, it is necessary to clean or replace the relevant devices very often. In addition, the viscosity of pre-mixed adhesives often changes rapidly inside the dispenser.
Although the Stream Jet piezoelectric jet valve is a non-contact dispensing valve, after correct aligning of both dispensing valves at the dispensing position, the two-component adhesive can be mixed and solidify at the same time to reduce device cleaning and maintenance time.
two-component_epoxy_mixing.jpgMixing & Dispensing